Backsplash and Floor Tile in Cutler Bay

Home › Tile Installation › Cutler Bay

Gold Hands offers tile installation in Cutler Bay, FL: floors, shower walls and pans, backsplashes and accent walls in porcelain, ceramic or natural stone, plus regrouting and repair of cracked or loose tiles. Every job is priced per project. Send photos and rough measurements by phone or WhatsApp and we return a free estimate, with no visit needed to get a number.

Requests we often get from Cutler Bay: regrouting a shower that still has sound tile, replacing a cracked kitchen floor that sits on a concrete slab, tiling a laundry room, or adding a backsplash before a home goes on the market. Each one is a different scope. Some are about appearance and some are about water getting where it should not, and we look at both when we review your photos.

Message (786) 788-8714 by text or WhatsApp with the basics: which room, the approximate square footage or length and width, and clear photos taken in daylight. If there is a stain on a ceiling below or a soft spot near a toilet or tub, photograph that too, since it changes the plan. We work in English and Spanish and answer with a per-project estimate.

Call (786) 788-8714 · Get a free quote

4.7 Google reviews · 35

4.9 on Thumbtack

Priced per project — free estimate by phone, video call or from your photos and measurements. Gold Hands Miami is insured.

Retiling post-Andrew houses in Cutler Bay

Cutler Bay sits in the path Hurricane Andrew took in 1992, so much of its housing was rebuilt or newly built afterward under stricter code, giving it relatively young single-family homes and townhomes.

Many homes in Cutler Bay were rebuilt or newly built after Hurricane Andrew in 1992, under a stricter building code. The concrete-block walls and slabs from that era are generally solid, which is good news for tile. The original interiors, though, are now old enough that floors, showers and backsplashes are due for replacement, and that is most of what we are asked to do in South Dade.

Tile from that period was often set on a thin layer of thinset over the slab, and some of it has started to loosen or sound hollow. When we remove it, we grind down what is left so the new floor starts from a flat, clean surface. We also look for slab cracks and treat them before new tile goes down, rather than tiling straight over them.

What is covered, from prep to grout

We list each item that applies to your project separately, so you can see where the prep ends and the finish work begins.

Cement backer board or foam board on shower and tub walls
Liquid or sheet waterproofing membranes in showers, tub surrounds and other wet areas
Shower pans, curbs, niches and benches built and waterproofed before tiling
Porcelain and ceramic floor tile, including wood-look plank and large-format sizes
Natural stone such as marble and travertine, sealed where the stone calls for it
Kitchen and bar backsplashes, with clean cutouts around outlets and window trim
Bathroom wall tile, tub surrounds and wainscot-height accent walls
Grout removal and regrouting, with mildew-resistant or epoxy grout options

Tile finish ideas

Illustration: large-format porcelain floor tile being set with leveling clips

Illustration: shower wall finished in herringbone tile with a recessed niche

Illustrative images — not photos of a specific Gold Hands project.

Floors and showers in concrete-block houses

Kitchen backsplashes are one of the most common tile jobs in Cutler Bay suburbs, often done along with new countertops or a paint refresh before a sale. We set backsplash tile after the countertops are installed, cut neatly around outlets and switches, and finish the bottom edge with a flexible caulk joint instead of grout, because that seam moves slightly as the house expands and contracts.

Garages, laundry rooms and covered patios in these houses are also good candidates for porcelain, which handles water, heat and heavy use. Patios that are open to rain need a tile rated for exterior use and a slight slope for drainage. We look at your photos to confirm whether the existing slab drains in the right direction before recommending outdoor tile.

Our tile process, step by step

Photos and measurements first: a wide shot, a few close-ups and the length and width of each area are enough to start. We answer with a free estimate priced for the whole project, not by guesswork.
A written plan: before work starts you get the scope, the tile and trim chosen, the grout color, a start date and the order of work, so you know which rooms are affected and when.
Permits where required: if the tile job turns into moving a drain, a valve or structural repair, we tell you before quoting. That part goes through our general contractor partner and the Town of Cutler Bay building department, separately from the tile.
Installation: demolition and haul-away, substrate repair and leveling, a membrane in showers and wet areas, a dry layout to place the cuts, then setting, grouting and sealing where the material calls for it.
Walkthrough and photos: we review every surface with you in good light, fix anything that is not right, leave spare tile labeled by room, and send photos of each stage for your records.

What sets the pace of a tile project

Hurricane season, June 1 through November 30, can shift schedules when storms close supply houses or delay deliveries, and it is a good reason to have materials on hand before a big floor is torn out. If the job grows into moving plumbing or structural work, permit review with the local building department adds time of its own, and we give you a realistic picture of that before you commit.

Tile Installation near Cutler Bay

Nearby: Tile Installation — Homestead · Tile Installation — Palmetto Bay · Tile Installation — Aventura.

All areas: Tile Installation across Miami-Dade and Broward. Planning guide: Choosing and Installing Tile That Survives Miami Humidity.

Neighborhoods and ZIP codes we cover in Cutler Bay

Cutler Bay (33190)

Tile Installation in Cutler Bay — questions we get asked

Can you tile over old tile or over terrazzo?

Sometimes. Tiling over existing tile or terrazzo saves demolition but raises the floor, which affects doors, thresholds and transitions to other rooms, and it only works if the old surface is flat and firmly attached. In many older homes the terrazzo underneath is worth a look before deciding. We review your photos and tell you whether covering, removing or keeping the old floor makes more sense.

What if a tile cracks or the grout fails after you finish?

Tell us. Send a photo by text or WhatsApp and we come back to look. Sometimes the cause is the installation, and sometimes it is something else, such as a slab crack that moved or a leak elsewhere in the house. We explain what we find and how we would fix it, and the spare tile we left labeled after the job makes the repair match.

Does hurricane season affect tile installation?

It can. Florida hurricane season runs June 1 through November 30, and storms can close supply houses, delay deliveries or pause work around landfall. We try to have tile and setting materials on hand before a large floor is torn up, so a delay does not leave you living on bare concrete. Exterior tile is scheduled with the weather in mind.

Do you come out to measure before giving an estimate?

Estimates are based on the photos and measurements you send, which is usually enough for a clear price. Take a wide picture of the space, close-ups of any damage, and the length and width of each area. If something cannot be judged from photos, such as a floor that may sit on a damaged subfloor, we tell you, and a paid site visit can be arranged.

Who buys the tile, you or me?

Either way works. Many clients choose tile themselves at a showroom or store, and we tell them how much to order, including extra for cuts and future repairs. Most of the time we supply the setting materials, membranes and grout. The written scope states exactly who provides what, so nothing is missing on the morning installation is supposed to start.

Other work we do in Cutler Bay

Need tile installation in Cutler Bay?

Send photographs of the job to (786) 788-8714 and a written quote comes back naming the scope and the materials. The quote costs nothing, and nothing reaches the invoice that was not on it.

Call (786) 788-8714 · Get a free Cutler Bay quote